Saint-Ambroise-de-Kildare, LanaudièreMon–Fri · 8 am–5 pm450 759-0472
Martin Remorques et V.R. Find my trailer
MARTIN REMORQUES / SALES • PARTS • SERVICE

Trailer frame and deck repair

A split board, a ramp that won’t close, a door that won’t lock: those repairs keep your trailer working and your load safe. Talk to our Saint-Ambroise-de-Kildare mechanics.

Wood deck of a flatbed trailer
WHAT’S INCLUDED

What takes the hits

The deck, ramps and doors work harder than anything else. Here is what we look at and repair.

Side cutaway drawing of an enclosed trailer: the frame and crossmembers, the wood deck, the E-track rail and D-rings, the roof seam, and the ramp with its hinge, springs and latch
Enclosed trailer, side cutaway
  1. Split, rotten or torn deck boards

  2. Enclosed trailer floors, especially along the walls

  3. Ramps, their springs and latches

  4. Doors, hinges and locks

  5. Roof and door seals on an enclosed trailer

  6. Tie-down points and rails

  7. Rust and damaged frame parts, assessed in person

  8. Parts ordered through our parts department

THE SIGNS

Before it lets go under load

Walk on your deck, open your doors, and look under the trailer.

Recognize one of these signs?

Call the shop or ask for an appointment. We’ll look at the trailer and tell you what it needs.

  • By touch

    A board flexes, sounds hollow or crumbles

  • By touch

    A ramp that’s heavy, crooked or won’t stay shut

  • By eye

    A door that no longer closes straight

  • By eye

    Water inside after rain

  • By touch

    A tie-down point that moves

  • By eye

    Rust swelling on the frame

HOW IT WORKS

We look before we talk parts

  1. You give us the picture

    Tell us what’s damaged and how. A clear description helps us plan the job.

  2. We look at the trailer

    Some damage only shows from below or once the deck is open.

  3. We tell you what to do

    What can be repaired, what gets replaced, and what can wait.

  4. We do the work

    Wood, hardware, ramps or seals: we plan the parts with you.

The deck, the hardest-working part

On a flatbed, the wood deck and ramps work the hardest. A wet deck that freezes and thaws eventually splits, especially around the bolts. A split board gets replaced before a loader or ATV wheel goes through it. On an enclosed trailer, look mostly along the walls and doors, where water collects.

Keeping an enclosed trailer tight

An enclosed trailer is protected by its seals. The roof, doors and vents let water in as seals age, and the floor pays the price. Open it after a heavy rain and look for traces. The sooner it’s caught, the shorter the repair.

What to look at under the trailer

The deck makes the most noise, but the underside tells the truth. Shine a light under the trailer and look at the crossmembers, especially near the axles and the coupler. Surface rust can be treated. Rust that swells, flakes or makes holes needs a real assessment, and that can’t be done over the phone.

While you’re there, also check the ramp and hinge mounts, the deck bolts and the tie-down points. Those parts take big loads at a single spot. If something moves when it shouldn’t, don’t load the trailer until it’s been looked at. Take a photo: it helps us prepare for the visit.

The Martin Remorques store and workshop, at 270, route 343
The store and workshop, at 270, route 343.

Making a wood deck last

A wood deck lasts longer when it can dry. Sweep off the snow, dirt and leaves that hold moisture, and avoid leaving a wet tarp lying flat for weeks. If the trailer stays outside, park it at a slight angle so water runs off. Check the bolts once a season: a deck that moves wears out its holes and eventually splits.

On a work flatbed, think about what rolls over it too. Tracks, buckets and loads on a small footprint crush wood long before it rots. Protective boards or mats in the right spots can save you from changing the whole deck too soon. On an enclosed trailer, a floor that swells or softens along the wall tells you there’s a leak somewhere: the seal has to be fixed first, or a new floor will meet the same fate. Before you decide to replace anything, measure what you have: board width and thickness, and how the boards are fastened, all make a difference to the parts. Trailers aren’t all built the same way, and a repair that fits properly lasts a lot longer than one that gets forced into place.

WORKSHOP APPOINTMENT

Book a workshop appointment

Tell us which trailer and what work: we call you back to set the date and plan the parts.

Rather talk to someone? 450 759-0472
Monday to Friday, 8 a.m. to 5 p.m.

Work needed

We call you back to confirm the date.

FREQUENTLY ASKED QUESTIONS

Your questions,
our answers

Ask a question
Can you replace my trailer deck?

Talk to us about it: the make, model, size and deck condition. Our mechanics look at what needs redoing and plan the parts with you.

My enclosed trailer leaks. What should I do?

It most often comes from the roof, door or vent seals. Open it after rain to see where water gets in, then book a time before the floor suffers.

Do you repair ramps and doors?

Yes. Ramps, their springs, hinges and locks are among the usual trailer repairs.

How much does a deck repair cost?

It depends on the size, the material and what we find underneath. We look at the trailer and talk it over with you before we start.

My trailer is rusty. Is it still worth it?

It depends where the rust is and how deep it goes. We look at the structure with you before talking about work, and if it has done its time, we’ll tell you.

How often should I check the deck bolts?

Once a season, and after a heavy load. A loose bolt lets the deck move, and that’s how wood ends up splitting.

Let’s talk it through

Your next project
Let’s talk

A trailer in mind, a part to find or maintenance to discuss? Get in touch with our team.

Talk to the team450 759-0472Mon–Fri · 8 am–5 pm