Saint-Ambroise-de-Kildare, LanaudièreMon–Fri · 8 am–5 pm450 759-0472
Martin Remorques et V.R. Find my trailer
4 min read

Snowmobile season: getting your trailer ready for the first ride

After a summer at rest, a snowmobile trailer deserves a full check before the trails: tires, bearings, brakes, lights, ramp, glide strips and tie-downs.

Tandem-axle enclosed trailer on a snowy lot

The trails open with the first big snowfalls. Before you load the snowmobile, the trailer that spent the summer in the yard deserves an hour of attention: it will make every trip of the winter, through salt, calcium and slush. Here is what to check, in order, before the first ride.

01

Tires after the summer

A tire that sat all summer loses pressure. Inflate each tire cold, to the value on the sidewall or the trailer label, and look for sidewall cracks. The manufacturing date is in the last four digits of the DOT code, the week then the year: Goodyear recommends replacing a tire that has been in service six years or more, even if it looks fine. See our trailer tires.

Close-up of a trailer tire under its fender
A tire that sat all summer loses pressure: check it cold.
02

Bearings and brakes

Winter is when a snowmobile trailer is on the road the most. If its bearings haven’t been inspected and repacked in the past year, as axle maker Dexter recommends, do it before the first ride. On a trailer with electric brakes, test the controller in the driveway, and check the breakaway battery and switch.

Do the weight math too: the empty trailer, plus the snowmobiles, fuel and gear. Your snowmobile’s weight is in its manual. At or above 1,300 kg (about 2,866 lb), or more than half the weight of the towing vehicle, the trailer must have brakes on all its load-bearing wheels. Our page on snowmobile trailers explains how to choose the right size.

03

Lights and plug

Salt eats away at contacts. Plug the trailer in and check every light: running lights, brake lights and turn signals, which have to work together with the vehicle’s. Clean the plug’s pins and replace a cut wire or a cracked housing before it leaves you in the dark. In snow and slush, keep the lights clean and check them before every trip. Our parts department carries trailer lighting and wiring.

Electrical plug in its holder on an enclosed trailer tongue
The plug and its wire are the first to suffer from road salt.
04

Ramp, deck and glide strips

With a snowmobile, the ramp works hard. Check its hinges, springs or cables, and the latch that keeps it closed on the road. On the deck, glide strips guide the skis and protect the floor from the track: replace any that are split or peeling. On an enclosed trailer, inspect the door and roof seals so the snow stays outside. Our service shop installs snowmobile glide strips, tie-down tracks and D-rings.

Snowmobile strapped in an enclosed trailer, skis on the glide strips
Skis on the glide strips: they guide the snowmobile and protect the floor from the track.
05

Tie-downs

A frayed strap, a seized ratchet or a loose anchor gets replaced before it lets go. Tie the snowmobile to the floor anchors, front and rear, and check the tension after the first few kilometres. At the cottage, a coupler lock keeps the trailer where you left it. See our tie-downs and straps and locks.

Orange straps holding stacked utility trailers on a flatbed
Straps on a load: same idea for a snowmobile, tight at the front and at the rear.
06

Salt, all winter long

On the highway, a snowmobile on an open trailer takes the salt, calcium and slush of every vehicle; in an enclosed trailer, it arrives clean and dry. The trailer, though, gets it everywhere. Don’t wait for spring: rinse it with fresh water, underside included, whenever the temperature allows during the winter, then thoroughly at the end of the season. A galvanized structure stands up far better to our winters’ corrosion.

Trailer wheels and underside covered in winter road salt
After a winter road, salt clings to the wheels, fender and underside: rinse them with fresh water whenever the temperature allows.
07

And behind the snowmobile?

For the camp, firewood or ice fishing, a trailer can also be towed behind the snowmobile. With its optional ski kit, the Bush Burro carries up to 950 lb in its 22 cu. ft polyethylene tilting box, which doesn’t rust.

08

The checklist before the first ride

  • Tires inflated cold, no cracks, in service for less than about six years
  • Bearings inspected and repacked within the past year
  • Brakes, controller and breakaway system tested
  • Lights and plug checked, pins clean
  • Ramp, latch, seals and glide strips in good shape
  • Straps, ratchets and anchors solid, coupler lock in the box

The complete maintenance schedule covers the rest, season by season. And if it’s time for a new trailer, see our inventory or talk to the team at 450 759-0472.