N&N Inno D3 utility trailers
The Inno D3 is N&N’s galvanized utility trailer for small projects around the house. Light and easy to handle, it tows behind a car and has all the qualities that make an N&N trailer last.

Not in the yard right now
Here’s what we have that’s close
The 3 models to order
Not in the yard? Martin Remorques orders this trailer from N&N in the configuration chosen with you.
Light and practical
At most 14 ft long, the Inno D3 moves easily by hand in the yard or garage. Its lighter open sides have little effect on your vehicle’s fuel use. A full-width rear ramp comes standard to load a mower or an ATV.
All the wiring runs inside the structure, out of the weather, and the ground connects inside the connector rather than being screwed to the frame: rust does not interfere with the lights. Anchored D-rings, checkerplate step fenders and an A-frame tongue complete the trailer.
Choosing an Inno
The small 51 × 99" model carries about 2,465 lb, for firewood, bags of soil or renovation material. The 66" wide models, single or double axle, 10 to 14 ft long, carry 1,700 to 2,300 lb and take a ride-on mower or an ATV. The ramp is rated 1,200 lb.
The 9 or 12" drop sides are chosen by what you haul: higher for leaves and debris, lower for loading from the side.
In practice
In spring the Inno D3 brings home bags of soil, shrubs and patio stones from the garden centre; in summer it takes branches and yard waste to the recycling depot; in the fall it brings in the firewood. It is the kind of trailer that ends up being used every weekend.
The 66" wide models, with the rear ramp, carry a ride-on mower or an ATV to the cottage. Because the trailer is light, it is easy to unhitch and push by hand into a corner of the garage or the yard, with no need to back it in with the car.
Good to know
Before you leave, check that the load is tied to the D-rings and that the drop sides are latched. The tires on a small trailer slowly lose pressure over time, so check them at the start of each season, especially if the trailer sat in storage all winter, and look over the lights before the first trip.
The models
- S-51X99Single axle, 51 × 99" usable, about 2,465 lb payload
- S-66X123Single axle, 66 × 121½" usable, about 2,310 lb payload
- T-66Double axle, 66" wide, up to 14 ft, 1,700 to 2,200 lb payload
Standard equipment
- Hot-dip galvanized steel
- Full-width straight rear ramp, 1,200 lb
- 9 or 12" drop sides
- Wiring inside the structure, ground in the connector
- Anchored D-rings
- Checkerplate step fenders
- A-frame tongue, triple pole model 72
Available options
In service
Galvanized steel needs little care: rinse off the salt in spring and check the side and ramp bolts. Before each trip, check the lights, tire pressure and hitch.
Once a year, have the bearings greased or checked. Our shop does this service and our parts department orders N&N parts.
Ordering at Martin Remorques
Tell us your vehicle and what you haul: we choose with you the size, axle and side height.
Martin Remorques orders this trailer from N&N in the configuration chosen with you. We first check that it suits your vehicle, your load and your use, we prepare the order with the manufacturer and we give you the expected delivery date. You can come and see the trailers in stock at our dealership, 270, route 343, in Saint-Ambroise-de-Kildare, Monday to Friday, 8 am to 5 pm.
For financing, we work with National Bank of Canada for individuals and Mitsubishi HC Capital Canada for businesses: we prepare the application with you; the institution approves it and sets the rate. Financing
After the purchase, our shop services and repairs your trailer: bearings, brakes, suspension, lights, wiring and hydraulics. Our parts and accessories department orders the parts you need, and we install the equipment that makes the trailer more practical, such as a winch, tie-down rails or a storage box. Service
More views


Your N&N quote
N&N Inno D3 utility trailers: tell us what you haul and with what vehicle. We suggest the model and its options, with its price.
Rather talk to someone? 450 759-0472
Monday to Friday, 8 a.m. to 5 p.m.
Does the Inno D3 have a ramp?
Yes, a standard full-width rear ramp rated 1,200 lb.
Can the Inno carry an ATV?
Yes, the 66" wide models take an ATV or a ride-on mower.
Why is the wiring inside?
To protect it from the weather; grounding in the connector also keeps rust from affecting the lights.
Does a sheet of plywood fit flat?
Yes, a 4 × 8 ft sheet fits flat in every Inno model, from the 51 × 99" to the 66" wide models.
How do I get the price of a N&N trailer?
Fill in the quote form on this page or call us at 450 759-0472. Tell us the configuration you want: we call you back with the model, the options and the price, Monday to Friday, 8 am to 5 pm.
Does Martin Remorques service N&N trailers?
Yes. Our shop in Saint-Ambroise-de-Kildare services and repairs trailers: bearings, brakes, suspension, lights, wiring and hydraulics. Our parts department orders the replacement parts you need.
Your next trailer
Shall we talk?
Tell us what you haul: we find the right model and its options, and we give you its price.




